OEM Custom Ductile-Iron and Grey-Iron Sand-Casting Parts — Selected Size, Color and Surface Treatment
Direct factory support
Get a quote that fits your project
Send your drawing or product reference, material grade and required quantity. Relia will review the requirements with you.
- Drawing & specification review
Confirm the supply scope and critical requirements.
- Samples before custom production
Review inspected samples before approving a batch.
- Inspection documents
Agree material and dimensional records for your part.
-
MaterialDuctile Iron & Grey iron
-
Product nameCustom Casting PartsSurface treatmentCustomers' Demand
-
SizeCustomized SizeColorCustomized Color
-
ServiceOEM SeriviceCertificationISO9001:2008
-
ProcessSand casting
Custom iron castings should be identified by the material and component drawing required for the order. This OEM enquiry covers ductile-iron and grey-iron sand-cast parts. Size, color and surface treatment are customer-selected, allowing the supply requirement to follow the actual component design.
Start with the selected iron grade and component
Identify the iron family and full grade required by the design. Show how the component fits within the intended assembly and which interfaces determine its use. The drawing and material requirement should describe the same part so the quotation can address a clear supply specification.
- Provide the component drawing and revision.
- Name the ductile-iron or grey-iron grade.
- Identify quantity and the required delivered condition.
- Mark critical dimensions and surface requirements.
Specify color and treatment through the finished condition
Describe the surface result needed for the component and the requested color where applicable. Identify any contact areas where treatment instructions affect fit or measurement. Since the finish follows the customer request, name the treatment required by the design rather than assuming a particular coating.
Make acceptance and qualification requests specific
State the dimensions, material evidence and surface checks needed to accept the selected casting. Identify any additional work requested within the quotation, with its required delivered condition. ISO9001 and ISO9001:2008 are the supplied qualification references; request the applicable current documents and supplier scope. Keeping the drawing, grade and acceptance criteria aligned gives the OEM order a defined technical basis.
