Wholesale Custom Grey Iron Ductile Iron Sand Casting Mechanical Spare Parts and Foundry Services
Direct factory support
Get a quote that fits your project
Send your drawing or product reference, material grade and required quantity. Relia will review the requirements with you.
- Drawing & specification review
Confirm the supply scope and critical requirements.
- Samples before custom production
Review inspected samples before approving a batch.
- Inspection documents
Agree material and dimensional records for your part.
Wholesale enquiries cover custom grey-iron or ductile-iron sand-cast mechanical spare parts. Identify the required iron family and complete grade for the actual spare. A component drawing and a clear definition of the supplied condition help establish what must be reproduced and how the ordered part will be accepted.
Capture the fit of the mechanical spare
Show the mounting arrangement, mating surfaces and any clearances needed in the existing machine. Mark the dimensions that control interchangeability and the datums used to measure them. If an old component is available as a reference, identify worn or damaged areas that should not define the replacement geometry.
- Provide a controlled drawing or dimensional requirement.
- State the complete grade and applicable material standard.
- Identify the machinery use and the required quantity.
- Mark assembly-critical interfaces and measurement datums.
- Define the required delivered surface condition.
Include additional work in the quotation request
Distinguish the casting request from any further operations required to make the spare ready for assembly. State the final dimensions and surface acceptance for those interfaces. This allows the quotation to address the requested scope without assuming that every component needs the same subsequent work.
Use one acceptance basis for approval and supply
Agree the dimensional, material and surface records required for the chosen part. Where sample approval is requested, identify the drawing revision and supplied condition used for that decision. Keep the same references in the production order so that the replacement can be checked consistently against the machinery’s requirements.
